We are located in NE Indiana about 30 miles west of Fort Wayne. Requirements for this postition are CNC turning and milling, must be able to work with minimal supervision. Working knowledge of G code and how to fixture a part. Mastercam programming is not required but will be a big advantage. Must be willing to do functions other than machining when required. Send a PM with your resume attached. Pre-employment drug screen is required.

Hello:
I have a Fadal CNC mill and Solidworks/Camworks. I live near Houston, Texas. Would you be willing to form out some of your work ?

Thanks

Sam

sbarziza@consolidated.net
936-539-4073
www.us-astro.com (http://www.us-astro.com)

Hello:
I have a Fadal CNC mill and Solidworks/Camworks. I live near Houston, Texas. Would you be willing to form out some of your work ?

Thanks

Sam

sbarziza@consolidated.net
936-539-4073
www.us-astro.com (http://www.us-astro.com)

Sam,
Don't you think the drive would be a little bit too long.

farm,farm.

Unless I had a turbo jet. Would you be willing to farm-out some of your work ?

Sam

Sam, Sorry, if I wanted to farm it out why would I run an add for an employee.