I need price and lead time on

FX0222 Needle Carrier Bond Nest Rev03 Qty 5
FX0223 Push Rod Carrier Bond Fixture nest Qty 5
FX0224 Cannula Carrier Bond Fixture nest Qty 5
FX0325-003 Lightguide Holder Rev01 Qty 4
FX0325-005 Fence Pin Rev01 Qty 12

I will close the RFQ on wednesday or sooner

This job will be awarded to someone in this forum.

Any questions:

clikas@hotmail.com

Hello clemente, How are you doing? I have some questions for you on your drawings.

FX0222 rev 3
All dim. apply after anodize correct. Do you want anodize included in the quote for all the parts that get anodize?
On the .142 dia x .47 dp. (section A-8 and B-7) is a drill point ok as long as you have your dia. to depth?

FX0223 rev 4
section B-4 (the A-A section) I see the 1.421 dim. and the .079 dim. What is the dim. for the step?

FX0224 rev 3
What is the length of this part? I have the .75 dim. and the 2.065 and .06 dim. I do not see the lenght of the part? and on the 2 x .156 dia x .50 dp (section A-7 and B-8) can you have a drill point for these holes? Also at detail B what is the dia. that the .062R run on (the large dia.) Is it .207R like p/n FX0223 and FX0222?

FX0325-003 rev 1
Would 1.00 stk dia. material be ok for this part?

On all the parts, I will take care of anaodize. All dimensions before anodize is OK

FX0222 rev 3

drill point is ok


FX0223 rev 4

step lenght 1.062"

FX0224 rev 3
lenght 1.125"
you can have a drill point in there.
the r is .0207 the same as the other drawings.

FX0325-003 rev 1

Stock material ok

Thank you, I will have a quote tomorrow afternoon.

I have emailed a quote to you. Thank you in advance for your consideration.

Thanks!
-Ryan

PM sent, Thanks

Is this job still open for quotation? I sent a PM to you. Thank you.

Regards,

This job was awarded to DD precision machining


Thanks