Good afternoon all,

I moved this RFQ from the manual machining section. I had originally planned to have the parts machined, but the cost was too high. So I am hoping to fabricate the parts via welding instead.

I have redesigned the parts to make use of some standard-sized square and cylindrical tubing. There are three types of parts. I call them the collar, sleeve and pivot.

1) Material type. I'd prefer to use aluminum (6061 or 7025), but only if you have the ability to retreat the parts after welding. If not, steel would be fine for the prototype.
2) Is a material quote required or is material supplied. Quote with material please.
3) Quantity I need 2 sleeves, 2 pivots and 12 collars.
4) Images attached as JPGs. Can provide dimensioned PDFs if that'd be easier.
5) Required time frame No rush. If I can get the parts by Jan/Feb that'd be great.
6) RFQ ending time open until I find someone to do the job

My email is santschi.1@att.net, I can work on a quote with just the jpg but the pdf would be best. I have a machine and welding shop so this is right up our alley. If you email me I can the call you or you can call me so I can check the details.
Thanks, Bryan

Email sent........talk to you soon.

Message Sent

Joe, Did you ever get your parts manufactured? Do you still need them done? Email me at wellerwelding@yahoo.com and I will be happy to assist you on getting your parts made.

Jim Bechtel

Mr. Martins,

If you have not found someone to take care of your needs as of yet, please contact me, and I will be happy to quote your project.

Sam Porter
sam_porter@centurytel.net

Joe,
Looking at your parts will respond tomorrow.
Kenny
478-836-5020

if this is still open for quotes, we would like to submit on your parts. Please let me know: greg@kernenconstruction.com