need price for 10, 20 or 50 pc

mild steel weldable material

WEST CANADA

Hello, I'd make these parts for $13.00 each for 10, $9.00 there after.
I don't know what shipping would cost yet; but if your interesred I can find out for you.
Eddie
eddie6675@yahoo.com

Is the tolerance of the ID for the bearing right?

Normally it is +/- 0.0003 (in the tenths, not in tousandths) so the bearing is hold tight without being deformed for excessive wall pressure.

I can give you a good price, but I don't want to start a war of prices here
how do I send private messages here? there is a subscription fee or something?

Best regards:
Everardo Rascon
erd39030@hotmail.com

That's a good point.:cool: P.M.s are pretty crucial on this site:rolleyes:

so I am sure it will work


email at

PLAZMACAM@YAHOO.com

The job was awarded to Everardo

THX

for reference, what was the winning bid?

Hi

At a rate of $45/hr, I offered him $6.5 per part with closer tolerances in the bearing chamber.

Thx Plasmaplasma :D

$5 each, 100 piece minimum

I am tring to send email to you and I am getting messages that my email was rejected because of my IP address. But I've tried from 3 different computers:
home, work and internetcafe.

Something is wrong with your email provider, I guess

Hi, PlazmaCAM

I just sent you an email with my other email addresses, to see if the problem is with hotmail or with my ISP

The last email I received from you was yesterday, about USPS using donkeys.

It appears that the money order finally arrived.
I will ship your job next week.

Thank you:
Everardo Rascon

I am tring to contact you by email but it doesnot work again

Just sent you an email.

Did you got it?

Thank you.

Please check your email

I am tring to contact you by email but it doesnot work again