| Check out the new CNCauction site, it's 100% free! Check out CNCzone for more RFQ's CNCzone.com. |
|
|
|
|||||||
| Register | FAQ | Members List | Calendar | Mark Forums Read |
| Turning Work Post your Lathe Turning RFQ in this section. |
|
|
|
 |
|
|
Thread Tools | Display Modes |
|
#1
09-16-2008, 10:29 PM
|
|||
|
|||
Short run Centerless/ cylindrical grinded made shafts.
I prefer email contact, thank you.
The shafts must be made on a centerless grinder or cylindrical grinder. Here is the drawing of the shaft (s) I need made. All diameters must be concentric to each other and the centerline cause the shaft will rotate at 150,000 rpms. The two shoulders between the .25 inch and 0.3125 inch diameter must be flat and square so my parts will sit on them squared. Please quote me and lead time (I need a fast service)? Just a reminder, LH means its a left handed thread and RH means its a right handed thread (long story, lol) I will give the two missing tolerance dimensions friday since I have to measure my parts ID. I just want you guys to have an idea of what needs to be done. Quote on the following: Material- steel 4140 and steel 4340. Quantity- unknown, please specify 1-5, 5-10, 10-15, etc. Lead-time - 1-3 days (urgent) I prefer email contact, thank you. Name: Sha D Email: yellowf40@gmail.com 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need short stainless round bar.. | StealthDumpTrucks | Scraps | 3 | 12-23-2008 09:27 PM |
| Key ways in long shafts????? | Amark Engineering/Manufac | Club house | 2 | 08-07-2008 11:58 AM |
| Rfq Precision Shafts | xa_shall | Turning Work | 7 | 01-21-2008 04:13 PM |
| CLOSED RFQ: Custom Shafts RFQ | xa_shall | Milling Work | 1 | 12-05-2006 11:49 AM |
| I need a few dies made | admin | Die Makers | 8 | 02-13-2006 03:56 PM |
Linear Mode
