| Check out the new CNCauction site, it's 100% free! Check out CNCzone for more RFQ's CNCzone.com. |
|
|
|
#1
11-20-2008, 11:49 AM
|
|||
|
|||
which section for stamping?
I'm looking for a quote on some large stamping I need done. Thin metal sheet (0.013") by 42" x 14" stamped to our specifications. I have the CAD drawings but I'm not sure which section would be appropriate to post for a quote on stamping. Any suggestions would be appreciated.
Thank you 
|
|
#2
12-15-2008, 10:22 AM
|
|||
|
|||
|
What volumes do you forecast, and what material? Tolerance on flatness may be an issue with this thin a material. Your requirements for edge finish may preclude some techniques such as laser cutting.
There are a lot of good local fab shops that could provide excellent value on low volumes. If you are forecasting larger volumes some tooling might be appropriate. Any additional information you can supply will help people respond
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| injectin die, stamping die, casting die manufactory from China | ellen | Manufacture Company Listing | 0 | 03-21-2008 08:36 AM |
| Can you make a CNC Foam Cutting RFQ section | seanreit | Site Support | 3 | 01-30-2008 02:50 AM |
| Post in the job section | rfqadmin | Club house | 0 | 02-21-2006 10:07 PM |
| Ballpark numbers for 20" spun aluminum sphere section... | InspirationToolworks | Turning Work | 3 | 02-13-2006 11:21 AM |
| Can you add a section for rapid prototyping services? | Grifftek | Club house | 3 | 02-04-2006 09:50 PM |
Linear Mode
