Waterjet Job (maybe laser)

[patriqq]

I have 3 blanks I want to have cut-out via waterjet, or possibly laser.

I can supply the material in the form of 0.188" x 3.25" x 48" 1060 HR bars.

I am open to using 0.188" 4140 plate or sheet for the "SK10" and "SK12", if you happen to have a source for that.

The "MRKnife" can be cut by either WJ or laser; I've been nesting 3 in the 3.25" wide bar. I don't think that can be pulled-off in a laser - you tell me.

The "SK10" and "SK12" must be cut in a WJ, because I need to counter-sink the holes (the laser makes them rock-hard if cutting with O2).

Tolerances, burrs, tabs, and rust are not an issue. Squareness-of-cut must be reasonable.

Quantity - approx 12 (10 to 15) of each to start.

please email Patrick - info@flyingsteel.com

thank you