Recent content by blurrycustoms

  1. blurrycustoms

    Swiss Lathe Work - Simple Delrin Part - 10,000+ Qty

    Thank you all. RFQ is now closed, we will be making a decision in the next couple of weeks, and will be in contact with the winning bidder via PM.
  2. blurrycustoms

    Swiss Lathe Work - Simple Delrin Part - 10,000+ Qty

    We need a quote for a run of 10,000pcs of the attached drawing: Material: https://www.mcmaster.com/#8576k12/=19gdbzs - Delrin - Black -If the above material is used, the OD of the part does not need to be turned. QTY: 10,000pcs RFQ Ends: 9/30/2017 Project start timeline is 2-3 months if...
  3. blurrycustoms

    Small steel part

    Hello all, Give me a little feedback here on this part regarding the material hardness. The drawing calls out for RC27 min, are you all not able to source this material in a pre-hard condition? We currently source this prehardened to RC30, so I don't think an additional heat treat step is...
  4. blurrycustoms

    Small steel part

    Pm box emptied.
  5. blurrycustoms

    Small steel part

    Re-attached drawing as jpg
  6. blurrycustoms

    Small steel part

    1) See drawing for material type 2) Supply material 3) 100, 250, 1000 pcs 4) Drawing attached 5) Timeline negotiable 6) North American suppliers only
  7. blurrycustoms

    Request For Quote- Multiple Aluminum Parts, Long Term

    Looks like we simplified drawinga a bit too much. Parts 1, 2, 3, and 6 are 1/4" thick.
  8. blurrycustoms

    Request For Quote- Multiple Aluminum Parts, Long Term

    In the attached zip files there are 7 part drawings. 2D dxfs and IGS files. Special callouts for any parts are listed in the PDFs. Dimensions should be derived from the DXF or IGS files for quoting purposes, and unless specified in PDFs, tolerances are +/-.004". More detailed part drawings...
  9. blurrycustoms

    Request For Quote- Small Delrin Part

    Thank you all, this part has now been awarded.
  10. blurrycustoms

    Request For Quote- Small Delrin Part

    Either will be fine
  11. blurrycustoms

    Request For Quote- Small Delrin Part

    Here is a challenging RFQ from a work holding standpoint. I have attached a PDF of the part, but the winning quote will be provided a dwg or dxf of the exact profile, for ease of programming. -Material is 1/4" Delrin. (We are aware that raw material is not of uniform thickness which is fine...
  12. blurrycustoms

    Request For Quote- Aluminum Turning/Milling

    Feel free to send them to info (a) blurrycustoms.com.
  13. blurrycustoms

    Request For Quote- Aluminum Turning/Milling

    Please note, that we have changed the drawing above, to open up some tolerances. Same file name, but the drawing is updated. Thank you.
  14. blurrycustoms

    Request For Quote- Aluminum Turning/Milling

    Hey all, More parts here for you to quote: Please quote out of 6061-T6 or better material supplied by you. Qty of 5, 10, 50 We will also consider quotes for just the turning operation of this part, please note this in your quote. Let me know if there are any questions.
  15. blurrycustoms

    Aluminum Turning

    Thank you all for the quotes, they ranged anywhere from $5 per piece to $130 per piece in quantities of 5. We have awarded this job to a fairly active member on this forum, and we will provide a review once the job is complete. More parts to come. Thank you again.
Top