Recent content by Dynamic Tool & Die

CLOSED THANKS FOR ALL THE QUOTES Hello, Looking for someone to make 100 pc.s 3-4 week lead time. H-13 steel ; 26 deg taper, .74 and .37 dia. with 3/16 hole drilled 1 inch deep. Break all sharp edges. Champher on 3/16 hole Good lathe finish. tolerance +.00 -.005 I live near Chardon. Oh...

My customer doesn`t need them anymore ,because the die will cost them more then they are willing to spend. Thanks for all your help.

Thanks for all your help Howard. It seems like the die is a little more complicated then I thought. Looks so simple but NOT. Thanks for all your help. Dave

I wonder if I could form the"U" shape with heavy springs in a striper??

Looks good. I think holding down the part with the striper on the 2nd form will keep the punches from breaking. Dave

If you don`t mind continuing every little bit would help. Dave

Yes that is what I was thinking, The part would be held down somehow on the 2nd form so the punches don`t brake. Now I`m trying to figure out the stripper plate so it holds it down on the second punch. Thanks Howard hopefully I can help you out someday. God Bless and happy Easter.

I will be using a die set and it will be in a punch press. Arrangement design is all I would need. Dave

Here is what I`m thinking

The inside of the "U" shape is .125 the outside of the "U" shape is .231 .125 plus material

How would I have the form bottomed out , then punch holes? Not sure how a 2 stage would die works. Dave

I would like someone to design the die. The material will move when it forms the "U" shape and I don`t want to snap off my punches when the die closes. Thank you

The material is cold roll .053 thick x .250 wide , the part is .250 wide x 14 3/4 long

Are there any stamping die designers that are willing to design this die for me? If so how much would you charge. Thanks

Hello everyone, I am trying to figure out the best way to build a die to make this part. I know the material will move when it is formed. I am trying to make it in 1 hit. I`m thinking pierce the 2 holes with .750 material between the holes, then form "U" shape and cut off between the 2 holes...