Recent content by mmachine

That would not be a problem

File is in the original post. It does not have to be clocked. Need the keyway as deep as possible in the bore

I am looking for 1pc of the attached shaft extension turned from steel. Std ball bearing tolerance on the 1.375" OD Slip fit on 1" OD & 1.625" bore No tight tolerances on lengths Only thing that will be difficult with this part is the blind keyway

Ordering today if anyone else wants to quote

Correct, 6 of each size. Thanks.

The drawing is in the first post in this thread.

Sent PM with email

I need some additional parts turned. 6 large, and 6 small. See original post for sketch and details. Need these ASAP so if you can make and ship them in the next few days please send me a quote via PM.

FYI, I paid more than your estimated quote to have a quality shop make these. I only got one bottom dollar quote, which was easily discarded.

Parts are ordered from a member here. Thanks to everyone who quoted. I got a wide variety of prices, but lead time was the deciding factor.

I'm not going to do it, but I would imagine you are going to get blasted for not reading my post about sending a PM and the rules about posting prices in the forums in big bold letters at the top of every page.

I am looking to have these turned from any mild steel. 22pc to sketch, and 4 additional pieces with a 2.777" OD Only tolerances that matter are bearing bore and OD can be -0 / +.001 The end opposite the bearing bore can be parted, saw cut, doesn't matter. It will be inside a roller. PM me with...