Recent content by skylargray

Jason, The project has been awarded.

Jerry, I sent you an email with details yesterday.

I sent a PM yesterday. You can always email me: skylar[at]skylargray[dot]com

Basic info: 1) Material = Trustone. This is a quartz/acrylic resin hybrid that simulates the look of stone but is supposedly easily machinable with typical woodworking or metalworking tools. http://www.randbcrafts.com/tru_stone.html http://rtresearch.com/trustone 2) I will supply the...

I have just recently awarded this job. Thank you to everyone who has offered a quote. I will attempt to contact everyone who quoted individually to inform them. The awarded price was more than 75% lower than the average quote. I received quotes for this job ranging from less than $2.00 up to...

Matt@RFR, Yes, using 1x1 stock is fine. The bottom of the part (the section that is 1"x1") does not necessarily need to be totally machined.

nmachine, Yes, the square hole can have clearance in the corners. For details, see the note at the bottom of my first post. Thank you, ~Skylar

That's a good point. ±0.002" is probably right on the edge of what you can achieve without additional passes. The square hole on the bottom does need to have a tighter tolerance than the rest of the part. A more realistic tolerance spec for economy would be ±.005 for the square hole and...

Greetings everyone, I am in need of a milled Aluminum 6061 part. The part is a pushbutton switch actuator. See linked PDF for details. Quantity: 10, 20 Tolerance: ±.002" Finish: mill / clear anodize Timeframe: flexible I would like quotes for 10 of these parts with mill finish, 10...