Maragnus
New Member
I have a project which requires the use of a CNC router table to build out my design. I am willing to travel three hours from the Auburn, Maine area. The design was created in SketchUp but I can provide it in other formats.
The plan is to use a 4' x 8' x 3/4" sheet of oak plywood which will give me 6 panels to make 3 tables. Each panel is 36" x 14". Precutting is fine of course as long as I get the same yield of panels. There are 6 - 6" diameter saucers as well which will need to be cut from a 1/4" board.
The plan is to use a 4' x 8' x 3/4" sheet of oak plywood which will give me 6 panels to make 3 tables. Each panel is 36" x 14". Precutting is fine of course as long as I get the same yield of panels. There are 6 - 6" diameter saucers as well which will need to be cut from a 1/4" board.