A Small Job, 5/8" Or 15mm Mic Or Atp Alum. Plate.

Status
Not open for further replies.

Wade Marshall

New Member
I have a small job for quote, one of each plate in pdf attached. Needs to be reasonably flat, off the shelf MIC or ATP is ok. All holes get a small center drill mark only. No finish work required. I have them in an older version of Autocad DWG file, of can make a DXF. If pricing falls in budget, the 2 smaller plates to the right need to be exactly 18mm thick, same material. Not sure if the pdf file will pass any scale info, the larger plate is appx 8"x16".

Thanks for your time.
Wade Marshall
 

Attachments

  • plates.pdf
    42.7 KB · Views: 91
Hi Wade,
Thank you for your inquiry at the forum.
We have the experience to process these parts, the price is reasonable.
You do not have the data PDF, DWG can send me mail?
kon@cncmachining.cc
If you have any questions please contact me!
Thanks!
Kon
 

Tony Parker

New Member
I have a small job for quote, one of each plate in pdf attached. Needs to be reasonably flat, off the shelf MIC or ATP is ok. All holes get a small center drill mark only. No finish work required. I have them in an older version of Autocad DWG file, of can make a DXF. If pricing falls in budget, the 2 smaller plates to the right need to be exactly 18mm thick, same material. Not sure if the pdf file will pass any scale info, the larger plate is appx 8"x16".

Thanks for your time.
Wade Marshall

Wade,
Can you send pdf to parkermachining@yahoo.com thank you.

Tony Parker
Parker Machining
(937)503-5509
 

lee12275

New Member
I have a small job for quote, one of each plate in pdf attached. Needs to be reasonably flat, off the shelf MIC or ATP is ok. All holes get a small center drill mark only. No finish work required. I have them in an older version of Autocad DWG file, of can make a DXF. If pricing falls in budget, the 2 smaller plates to the right need to be exactly 18mm thick, same material. Not sure if the pdf file will pass any scale info, the larger plate is appx 8"x16".

Thanks for your time.
Wade Marshall


Wade,
If you can send me the drawing file I can get you a good price on the plates
kmoore04@comcast.net
Thanks
Lee Moore
L&R Machine
Mt. Juliet Tn
 

Jimmy Sams

New Member
I have a small job for quote, one of each plate in pdf attached. Needs to be reasonably flat, off the shelf MIC or ATP is ok. All holes get a small center drill mark only. No finish work required. I have them in an older version of Autocad DWG file, of can make a DXF. If pricing falls in budget, the 2 smaller plates to the right need to be exactly 18mm thick, same material. Not sure if the pdf file will pass any scale info, the larger plate is appx 8"x16".

Thanks for your time.
Wade Marshall
Hello Wade,
This will be no problem if you can send the dimensions & prints, we'll be more than glad to quote as we are a small or large job shop.
Thank you, Jimmy Sams,
ctsmanufacturing.org
 
Status
Not open for further replies.
Top