Prototype Needed Aluminum 6061 Waterjet Project

Discussion in 'Laser, Waterjet, and Plasma Work' started by Yianni - VJ, Mar 2, 2018.

Thread Status:
Not open for further replies.
  1. Yianni - VJ

    Yianni - VJ
    New Member
    18
    0
    1
    NYC
    Hello,

    I would like a quote for the attached file.

    - Aluminum 6061
    - Vendor provides material.
    - 1/4" thickness.
    - Sandblast finish.
    - File units are in Millimeters.
    - Please specify if you can apply clear anodizing at additional cost.

    Thank you for your consideration.
     

    Attached Files:

  2. Sam Schmitt

    Sam Schmitt
    New Member
    7
    1
    3
    Hello,

    Can you please provide dimensions and tolerances? Is this for 1 piece only? I did not see any dimensions on the prints. If you have solid model or dxf please send to info@kandsmachining.com

    Thanks!
     
    Chris Abbott likes this.
  3. Yianni - VJ

    Yianni - VJ
    New Member
    18
    0
    1
    NYC
    Sorry, I was under the impression you can get dimensions in any software if you import the PDF in millimeters.
    Dimensions are 310x 230mm
    Tolerances are 0.1mm
    Yes this is one piece.

    Email sent with .stp attachment.
     
  4. Craig Wilson

    Craig Wilson
    New Member
    2
    0
    1
    Hi Yianni
    Where would you need this shipped to?
     
Thread Status:
Not open for further replies.

Share This Page