Request For Quote- Fiberglass Entry Door Color Sample Swatches

Status
Not open for further replies.

fuse2marketing

New Member
Request for sample swatches to be cut from fiberglass entry door skins. Size is approximately 2" x 3.5" with rounded corners (.25" radius) and .25" round hole at one end for assembly onto ring that holds all samples. Material is fiberglass (3/32" thick) and is pre-finished in one of eight colors. Need up to 1000 swatches of each of eight colors. Also need inkjet printing on back to identify color name. Please advise of pricing and turnaround time plus shipping to Louisville, KY.
 
Hello, i have a few questions about this job. are you supplying the material? and is the color finish a gelcoat application or actually tinting the fiberglass resin in unicen with the MEKP catalyst? either way this is right up our alley, we have made numerous material sample, color, density ETC swatches. please check out our website www.masterpiecemodels.com if you would like some assurance. email me at garrett.gordon@masterpiecemodels.com with any other information you have and we can get you a quote by the end of the day tomorrow!

Thanks,
Garrett
 

depryor

David Wolfe Design, Inc.
How large is the prefinished sheet to begin with, a standard 36"x84" entry door? We have 2 large 5-axis routers with capacity up to 6 feet wide or 11 feet in length.
The size of sheets would determine the number of set-ups and consequently the piece price.
We are located in Akron, OH and have a lot of buisness in the greater Louisville area. Also would we be responsible for assembling the ringed kits or just shipping the cut samples in bulk?
Please email any additional information to info@davidwolfedesign.com

Thanks!
 
Status
Not open for further replies.
Top