Forum Question

Discussion in 'Site Support' started by Taflin, Apr 27, 2012.

  1. Taflin

    Taflin
    New Member
    If I have some work the requires milling and a lathe, where should I put it?
     
  2. burk

    burk
    New Member
    I'd say post it in the category of the most involved details. Say, if you have a basic round part but with a lot of milling detail, put it in milling. If it has a lot of turning detail, and just a couple milled details or off-center holes etc., put it in lathe work. something like that anyway
     

Share This Page