Need large lathe part made ASAP

Status
Not open for further replies.

Briscoe

New Member
Hello All,

PLEASE READ AND NOTE EVERYTHING BELOW.

I need the attached lathe part made ASAP. Material is 6061 aluminum. We can supply the material.
The ID bore is NOT critical as it is just for weight reduction. If you can't bore the part as deep as the print specs that is ok- just include in your quote the depth you can go. Just get the the ID to within +-.100

The OD specs are critical and need to be +-.005 please. NOTE THE .125 DEGREE TAPER: SEE PRINT
The 1.000 shoulder length is also critical: +-.005 please

Surface finish: Please also include in the quote turn-sanding the OD surfaces to about 1000 grit. IT IS VERY IMPORTANT THAT THE OD SURFACES BE CLEAN. This thing is going to part of a mold.

We are in Columbus Ohio- it would be best if you are somewhat close- but this is not a deal killer if you are not. (Just worried about shipping cost)
Please let me know if the print isn't adequate.

Please email/call me here at:
Wolfden Products
614-282-6862
bbriscoe@wolfdenproducts.com
 

Attachments

  • PRINT01..jpg
    PRINT01..jpg
    14.9 KB · Views: 65
  • INSERT DRAWING02..DXF
    127 KB · Views: 32
Status
Not open for further replies.
Top