Request For Quote- Qty 2,000 small aluminum clamp

Status
Not open for further replies.

Rower

New Member
Thank you all for your responses and I'm sorry I didn't get back to everyone. I got quite a few more responses than I expected. The RFQ is now closed.

This site is great... I will be back! Thanks again.
 

John Taylor

New Member
Hello,

This RFQ is for a small aluminum clamp body, about 45 x 69 x 12.7mm (1/2" plate), made of 6061-T6. The plate would require 2D milling or perhaps waterjet/laser to cut out the profile, and then requires three tapped holes on two sides of the plate. It needs to be anodized. Initial quantity of 2,000 pieces is required by September, with additional orders of about 500 expected in in the following months for the foreseeable future. If you are interested, please send me your contact information and I will email a drawing for quotation.

Thank you,
John


Hi, I'm a start up in Seattle, would love the opportunity to earn and keep your business, if you don't mind please send me the print so I can quote you.
 
Status
Not open for further replies.
Top