Request For Quote- Qty 2,000 small aluminum clamp

Not open for further replies.


New Member

This RFQ is for a small aluminum clamp body, about 45 x 69 x 12.7mm (1/2" plate), made of 6061-T6. The plate would require 2D milling or perhaps waterjet/laser to cut out the profile, and then requires three tapped holes on two sides of the plate. It needs to be anodized. Initial quantity of 2,000 pieces is required by September, with additional orders of about 500 expected in in the following months for the foreseeable future. If you are interested, please send me your contact information and I will email a drawing for quotation.

Thank you,

Can you please send a print or fileto
thanks alot
Not open for further replies.