Request For Quote- Qty 2,000 small aluminum clamp

Status
Not open for further replies.

gmachine84

New Member
Hello,

This RFQ is for a small aluminum clamp body, about 45 x 69 x 12.7mm (1/2" plate), made of 6061-T6. The plate would require 2D milling or perhaps waterjet/laser to cut out the profile, and then requires three tapped holes on two sides of the plate. It needs to be anodized. Initial quantity of 2,000 pieces is required by September, with additional orders of about 500 expected in in the following months for the foreseeable future. If you are interested, please send me your contact information and I will email a drawing for quotation.

Thank you,
John

Can you please send a print or fileto gpmw51@comcast.net
thanks alot
 
Status
Not open for further replies.
Top