RFQ - 2 pieces CNC'd aluminum emblem

[dallas4u]

This is a small job, only two pieces, not very complicated. I'm looking to have an emblem made for my motorcycle tank (one piece on both sides, so two pieces). Here's what I need:

Attached is a JPG (for viewing) and a DWG of the emblem. Specs are:

- 5052 Aluminum (or whatever grade you may have around that will work fine), brushed.

- 8.5" L x 1.5" W

- .25" thick

If the design can be almost completely routed out instead of being routed/etched into a rectangular block it would be preferred, but I will listen to whatever opinions you guys have for me... you are the masters!

There is more talk about this design HERE. Please take a look and see if this answers any questions you may have.

Thanks!!!

 

[MrHorsepower]

I have an awsome Idea for this. I will send you a PM Fri eve.-Dave

 

[dallas4u]

Whoa... thanks! I'm looking forward to seeing what you come up with!!!

 

[dallas4u]

Thank you to all that have replied or contacted me. The work has been asigned!