can you tell me the price and delivery time on this:
material - mild steel, something that is weldable & machines nice.
dimensions:
.375 OD
1.250 OAL,
drilled thru @ #3 drill size, or appropriate tap drill size for 1/4 x 28 thread
thread to 1.000 depth with 1/4 x 28, which seems to be the depth of a bottoming tap. If running two taps down this would add to the cost alot, going with a taper tap might be just fine. But maybe you fancy guys don't use taps, so let me know.
Pretty loose OAL tolerance on these +/- .015 on length, I would just assume you use 3/8 OD round stock, and not fuss with the OD at all.
Slight deburr / edge break OK on OD of ends, ID chamfer not required.
quote on 50, 100 & 250
thanks,
rb
material - mild steel, something that is weldable & machines nice.
dimensions:
.375 OD
1.250 OAL,
drilled thru @ #3 drill size, or appropriate tap drill size for 1/4 x 28 thread
thread to 1.000 depth with 1/4 x 28, which seems to be the depth of a bottoming tap. If running two taps down this would add to the cost alot, going with a taper tap might be just fine. But maybe you fancy guys don't use taps, so let me know.
Pretty loose OAL tolerance on these +/- .015 on length, I would just assume you use 3/8 OD round stock, and not fuss with the OD at all.
Slight deburr / edge break OK on OD of ends, ID chamfer not required.
quote on 50, 100 & 250
thanks,
rb