Request For Quote- Two Small Parts Needed In Kovar

Discussion in 'Turning Work' started by amasters, Jan 23, 2018.

Thread Status:
Not open for further replies.
  1. Hello,

    We are building some prototypes before we go into production and need some parts made.

    Please quote the following two (2) parts in qty of 1, 2, 3, and 5 pieces each.
    Material: Kovar Please quote with or without material supplied.
    Time frame: 2-3 weeks
    Note: Ignore the plating requirements and the "pin" requirements.

    EDIT: If preferred, I can supply the 1.25" dia. Kovar rod. Some have stated that Kovar is difficult to source or expensive. Please be clear in your quote if you are supplying the Kovar or not.

    Please ask questions and make suggestions if they could ease machining etc.

    Contact Andy at amasters(at)customthermoelectric(dot)com

    Thank you.
     

    Attached Files:

    Last edited: Jan 31, 2018
  2. cody

    cody
    New Member
    8
    1
    3
    Would this be a repeat order?
     
  3. Cody,

    It could easily be. These are 2 pieces that go into a few prototypes for a customer. If they are happy, they will buy in larger quantities.
     
  4. Brendan Gibbons

    Brendan Gibbons
    New Member
    24
    0
    1
    I sent you a message
     
Thread Status:
Not open for further replies.

Share This Page