josephmartins
Geek n Gearhead
Good afternoon all,
I moved this RFQ from the manual machining section. I had originally planned to have the parts machined, but the cost was too high. So I am hoping to fabricate the parts via welding instead.
I have redesigned the parts to make use of some standard-sized square and cylindrical tubing. There are three types of parts. I call them the collar, sleeve and pivot.
1) Material type. I'd prefer to use aluminum (6061 or 7025), but only if you have the ability to retreat the parts after welding. If not, steel would be fine for the prototype.
2) Is a material quote required or is material supplied. Quote with material please.
3) Quantity I need 2 sleeves, 2 pivots and 12 collars.
4) Images attached as JPGs. Can provide dimensioned PDFs if that'd be easier.
5) Required time frame No rush. If I can get the parts by Jan/Feb that'd be great.
6) RFQ ending time open until I find someone to do the job
I moved this RFQ from the manual machining section. I had originally planned to have the parts machined, but the cost was too high. So I am hoping to fabricate the parts via welding instead.
I have redesigned the parts to make use of some standard-sized square and cylindrical tubing. There are three types of parts. I call them the collar, sleeve and pivot.
1) Material type. I'd prefer to use aluminum (6061 or 7025), but only if you have the ability to retreat the parts after welding. If not, steel would be fine for the prototype.
2) Is a material quote required or is material supplied. Quote with material please.
3) Quantity I need 2 sleeves, 2 pivots and 12 collars.
4) Images attached as JPGs. Can provide dimensioned PDFs if that'd be easier.
5) Required time frame No rush. If I can get the parts by Jan/Feb that'd be great.
6) RFQ ending time open until I find someone to do the job