asifellahi
New Member
Hello. I need a quote for the attached images / job
I am trying to make a chair. I am not very good with verbal explanation but more of a visual person so please bare with me.
Attached is an image of a cardboard chair.
----------- PART ONE ---------------
I will be making one like this. The side panels will be made from hard plywood (2 panels laminated together making a thickness of 50mm) and the connecting tubes from aluminium tube (1000mm x 65mm outside diameter and 55mm inside diameter)
The problem is connecting them securely.
Please see attached diagram of how I think it may work.
I need a quote on a price for 7 x 1000mm tubes with each end threaded inside - polished finish.
I need a quote for the (flanges if that's what they'll be called) as per attached drawing (please ignore scribbles) with o/s thread to screw into inside of tube. 14 off - again polished finish. The part of the flange (outside which will be seen) good quality engraving 'THE BIRMINGHAM CHAIR CO. - EST. 1974'
----------- PART TWO ---------------
Also attached is some basic artwork of a name plate i would like making (either by heavy press or engraved)
Sizes - to be in proportion to the width which is 10cm. Sheet must be no more that 2mm thick. There will also need to be two holes which I have forgotten to put onto the artwork for rivets / attachments. Writing / raised edges must be highly polished.
***********SORRY - HAD PROBLEMS ATTACHING THREE OTHER PHOTOS - Can email them later *********
Can email on asifellahi@live.co.uk or call on 07515 015 866
I am trying to make a chair. I am not very good with verbal explanation but more of a visual person so please bare with me.
Attached is an image of a cardboard chair.
----------- PART ONE ---------------
I will be making one like this. The side panels will be made from hard plywood (2 panels laminated together making a thickness of 50mm) and the connecting tubes from aluminium tube (1000mm x 65mm outside diameter and 55mm inside diameter)
The problem is connecting them securely.
Please see attached diagram of how I think it may work.
I need a quote on a price for 7 x 1000mm tubes with each end threaded inside - polished finish.
I need a quote for the (flanges if that's what they'll be called) as per attached drawing (please ignore scribbles) with o/s thread to screw into inside of tube. 14 off - again polished finish. The part of the flange (outside which will be seen) good quality engraving 'THE BIRMINGHAM CHAIR CO. - EST. 1974'
----------- PART TWO ---------------
Also attached is some basic artwork of a name plate i would like making (either by heavy press or engraved)
Sizes - to be in proportion to the width which is 10cm. Sheet must be no more that 2mm thick. There will also need to be two holes which I have forgotten to put onto the artwork for rivets / attachments. Writing / raised edges must be highly polished.
***********SORRY - HAD PROBLEMS ATTACHING THREE OTHER PHOTOS - Can email them later *********
Can email on asifellahi@live.co.uk or call on 07515 015 866