Quote for 316 Stainless part

Status
Not open for further replies.

quentinlong

New Member
Quote required for 316 Stainless Steel part.
Material is required
Initial run of 10 units.
Required by 1 November 2007
RFQ ending time 1 October 2007
Please contact me at quentin@apnea.co.nz
No preference for where in the world this work is performed.
These need to be shipped to Wellington 6001, New Zealand, so quotes need to include cost of shipping.
.DXF file can be supplied.

Please find attached an image of the part.
 

Attachments

  • mech.pdf
    57.1 KB · Views: 296
Last edited:

quentinlong

New Member
Tolerences of +/- 0.100mm are required.

Some additional information:
The 4.0mm radius hole in the end is 32.0mm deep, and is only in one end.
The 6.35mm slot is 25.8mm deep.
 

quentinlong

New Member
The only suface that will be visible is the top, so that will need to have at least a milled finish. Every other surface requires no additional finishing.
 

Attachments

  • TRIGGER_HOUSING_FOR_QUOTE.DXF
    23.8 KB · Views: 78

quentinlong

New Member
I am initially looking at 10 units.
The grade of Stainless steel is plain old 316 - for use in sea water.

As a good number of quotes are still coming in, I will award this when 1. the quotes dry up, or 2. the 1st October. Whichever comes first.
 
Status
Not open for further replies.
Top