Could somebody give me a quote to cut the following:
The files are CAM/NC files, they are 5 boards of MDF 4' x 2' x 3/4'
The origin for the boards is the lower left corner the Z axis is positioned on the top of the surface.
Board 1
Board 2
Board 3
Board 4
Board 5
Cutting is done with a flat end 1/4" end mill (upcut 2 flute). the depth per pass is set at .17"
Due to the weight of this i would ideally require this to be cut in the UK.
If you require any further info please ask.
I only need one set at present.
The files are CAM/NC files, they are 5 boards of MDF 4' x 2' x 3/4'
The origin for the boards is the lower left corner the Z axis is positioned on the top of the surface.
Board 1
Board 2
Board 3
Board 4
Board 5
Cutting is done with a flat end 1/4" end mill (upcut 2 flute). the depth per pass is set at .17"
Due to the weight of this i would ideally require this to be cut in the UK.
If you require any further info please ask.
I only need one set at present.