I have a lot of 10 1/2" end mills that need resharpening. I also have a 5/16 drill mill that needs a new 90 degree end. Can you also do a 45 degree corner chamfer. I have a few other end mills all is in carbide and if you could do TIALN that woudl be the cats meow, but what I need is mainly...
I provide the material which is 4140 PHT and is sized 5.650 long by .392 wide by .969 tall all within +/-.003" tolerance. What I need done is a .130 through hole with a .217" counterbore .877" deep. Then a .217" hole and finally a .250 wide slot .240 Deep with "MM USA" engraved in there. The...
You definately need a bottom view in order for us to know what is going on Section AA is kind of confusing and where aexactly teh features of section BB and CC are, is not shown anywhere on the drawing. All thsi would be cleared up if you had a bottom view.
For some one that wants to say how long a part should take to make, first you should learn that aluminum does not get ground. Please tell me why. Those of us that know how a 3 hr quote ends up being 10 hours worth of work, please don't tell him why, let him figure it out on his own.