Recent content by Tolix

Thank you for the few quotes received. Job has been awarded. Thanks again! -V

Greetings. I am looking to have 5 sets of rods drilled from .079" (2mm) rod stock. These parts will be tested for crimping of music wire. Rod stock should be of stainless steel alloy- formable, so it does not rupture. Advice on the proper rod alloy will be appreciated; by default going for...

Parts have been ordered. Thank you.

Hello, please quote LVDT Mount: 1 each TBS Block: 10, and 100 each LVDT mount was designed around a 3" AL L-channel, which I can supply. TBS blocks need to have specified roughness on two sides, as well as material certification. Thank you.

Thank you for the input Dualkit. Tolerances and delivery time are priorities on these parts, so most likely will go with a shop in North America.

After responding to all requests I have received one quote from overseas. I am looking forward to more options. Many thanks.

I can supply the .079 (2mm) stock 303 stainless from Mcmaster in 1 or 3ft lengths. We need the smaller quantities in under two weeks; ideally within one week. Please quote: Connecting rod: 40, 100 each Spring rod: 80, 200 each - Thank you.

Thank you everyone for your input. This job has been awarded and parts are being made.

Manufacturing of this component is bound to get easier once we receive the first set of custom (holed) extrusions. For now we need six machined prototypes. Please let me know if this part can be machined, as well as the cost for 6 each in AL 6063-T6 or AL 6061-T6. 3D model is available...

If sheet thickness tolerance can stay within -.005 +.010 then we should be okay, but I know that this varies by supplier. And .071 dimension is from the horizontal / leading edge.

Greetings, Please quote included drawing with quantities of 40 and 200 each. Material: AL6061-T6 or other tempered aluminum alloy Prefer shop supplied material. I can provide 3D files upon request. Thank you.

Grate ! (great) I will get in touch with them. Thank you.

I am looking for a north American metal forming company to manufacture stainless steel drain assemblies. Any suggestions would be kindly appreciated. 9x3 inch QTY's 500 to 5000

Thank you everyone. I have a handful of quotes and will make a decision by end of Monday. Thanks again.

Rich, I did not see a PM from you. Please re-send. Thanks.