Request For Quote- 80 steel parts

[millman52]

Please find a .dxf file attached of part.
Material is 1045 Turned Ground & Polished.
Open for bids till June 3 2009.
If bid awarded parts must be shipped within 14 working days of bid award.
Bidder must supply material
Parts must be free of all burrs & chips & must be protected from oxidation during shipment

Please submit any questions & bids to:
mullinsmachining@hotmail.com

Drawings revised 05/20 7:57 AM



After consulting with end user. Center hole can be drilled "X" drill as long as Total run out is .005 or less

 

[bobk]

Do you have a source for this size and type of material in TG&P?

 

[Dualkit]

Any chance to substitute A-2 Tool Steel? I have about 20 feet ground to 20mm
lying around.

 

[donatello tam]

pm sent with questions. I'm looking forward to receive your reply, thank you very much.

 

[millman52]

Any chance to substitute A-2 Tool Steel? I have about 20 feet ground to 20mm
lying around.

Tool steel I'm sure will be ok. Just is more expensive.

 

[TMSCO]

quote sent via email

 

[millman52]

Thanks to all that have submitted quotes.

BID HAS BEEN AWARDED.

 

[Dualkit]

Would you mind disclosing the winning bid? Considering the tolerances and stock requirements ( ground & polished ), I thought I had a good shot on this one.