Prototype Needed Aluminum coupling hub

[can773]

Hello,

I need two of these components made up for my model airplane. Cost is of primary concern, timeframe is wide open.

Material is 7075 T6, 3/4" round bar, OD does not need finishing to dim shown on drawing, as is finish on round is ok.

I didn't tolerance the drawing, +/- 10 thou is fine on everything except the location of the 8mm central hole, and the location of the two 4mm outer holes, they should be 5 thou or better. I didn't dimension it that well to consider stackups but I was in a hurry

If you can do this work, please send a quote to

chadnortheast@shaw.ca

Also they will need to be shipped to Calgary, AB Canada.

Thanks,

Chad Northeast

 

[RCreations]

Chad,
I've modeled your part for your review.

I can machine your part and ship it to you inside the US for $25.00 ea. After I get your approval and at least a 50% payment through PayPal. I will ship your part through FedEx Ground or USPS Priority Mail.

Contact me for payment information.

Attached is a screenshot of your part.



Thanks,



Tony
Ross Creations
__________________
tross@oh.hra.com
Phone # 336-516-4231

--------------------------------

 

[ethinds]

prop hub

2. each 80.00 plus shipping 3. day turn around

Ed Heigl @ E.T.H Industries
27415 Jonquil Ave Elko MN
55020 612-242-0761

 

[Huebert Machine]

Chad,
I tried to send you a quote through your e-mail acount. And never heard anything back from you.I would be happy to provide you with a quote.Please feel free to contact me at huebertmachine@yahoo.com