Request For Quote- CUSTOM PIN GAGES needed... Stainless Steel, 26.5mm - 60mm by .5mm increments

[twp]

I need to get a price from somebody to make me custom PIN gauges out of stainless steel either 303 or 304 series..

-Sizes: 26.5mm thru 60mm by .5mm increments (70 pieces total), each piece 2" long.
-45 degree chamfer on both ends to cut the sharp edges
-stamped or laser marked with the size on at least one end
-Tolerance -.001", +.000"

shipped to northern, NJ.

Thanks

 

[contract_machining_inc]

I need to get a price from somebody to make me custom PIN gauges out of stainless steel either 303 or 304 series..

-Sizes: 26.5mm thru 60mm by .5mm increments (70 pieces total), each piece 2" long.
-45 degree chamfer on both ends to cut the sharp edges
-stamped or laser marked with the size on at least one end
-Tolerance -.001", +.000"

shipped to northern, NJ.

Thanks

Hi, we have an OD grinder that can handle that capacity but you will have some extremely expensive pins. Have you tried Van Kuren?

 

[twp]

no what is: Van Kuren ?

 

[beege]

Gage Specialists:

http://www.pmclonestar.com/vankeuren.asp

Some of the old vK workers went here:

http://www.bostoncenterless.com/pingage.htm

 

[gtweed]

twp,
will a lathe turned 32ra surface finish be OK.
g.tweed