cmichalski
New Member
I'm looking for a quote on a single piece ellipsoidal bulb reflector turned from brass. I've included links for the SW2011 solid model as well as a PDF print. The surface finish of the inside of the reflector can be 32micro-inch as I'll end up polishing it to Nickel plate it later.
This is my first time posting here so depending on the response I may try posting the remainder of the job (my usual source doesn't have an easy means of programming the elliptical path so I'm most interested in this one part).
https://www.dropbox.com/s/wkcpr1drd1ymant/Custom Ellipsoidal Reflector.SLDPRT
https://www.dropbox.com/s/nmmivr485vvx6s6/ELLIP-03-044 - ELLIPSOIDAL REFLECTOR.PDF
Thanks,
Chris
This is my first time posting here so depending on the response I may try posting the remainder of the job (my usual source doesn't have an easy means of programming the elliptical path so I'm most interested in this one part).
https://www.dropbox.com/s/wkcpr1drd1ymant/Custom Ellipsoidal Reflector.SLDPRT
https://www.dropbox.com/s/nmmivr485vvx6s6/ELLIP-03-044 - ELLIPSOIDAL REFLECTOR.PDF
Thanks,
Chris