No Rfq/ Cnc Lathe Work Offered

Discussion in 'Turning Work' started by Will Andrade, Sep 20, 2018.

Thread Status:
Not open for further replies.
  1. Will Andrade

    Will Andrade
    New Member
    5
    1
    1
    Hello Everyone,
    I might be breaking the law here, but please read...
    My name is Will Andrade and Im located in Pearland, Texas. I have done machining for over 15 yrs. So I did a recent purchase of a small cncn lathe. Fortune Vturn-26. Max turning dia. 15”, Max between center distatance 24”. 10” Chuck. 3” thru hole. Looking for an opportunity to manufacture parts. Prefer to do bussiness localy, as I prefer COD. Seen some guys doing what Im doing that had it bad at times. But I’ll take a shot at some RFQ from out of state. Please contact me for your needs.

    Thank you for your time and I’m looking forward to speaking with you!
    Will Andrade
    Will_1717@yahoo.com
    Cell: 832-425-5588
     
    Amlie likes this.
Thread Status:
Not open for further replies.

Share This Page