Hello again, Yup I figured I forgot some details here.
OK, On Part 1, tolerance of + 0.000/- 0.002 applies to where it says smooth(arrowhead) and is basically the surface finish of polished steel, and only on that part of the piece. The rest of the part is standard machine finish with +/- 0.005 tolerances. Steel type, any.
Part 2, +/- 0.005 with standard machine finish. The chamfer was only to show break all sharp edges.
Part 3, same tolerances as part 2, but the 2mm deep bore tolerance is +0.002/- 0.000, and standard machine finish.
I would need these parts within a couple of weeks if possible.
I hope this clears things up.
Thanks for your consideration.
