Request For Quote- Small shafts with tapped hole and flats milled. Need 100 and 50

Status
Not open for further replies.
B

BehemothDT

New Member
I have 2 different shafts I need made. Mild steel. I need 50 of the "Detent shaft 2" and 100 of the "Detent shaft 1".
I've tried to attach a print. The print will show flats milled, and a tapped hole. I've made a fixture to hold the shafts 2 at a time in the Bridgeport's vise for the milling, but I'd prefer to get them all the way done.

PDF links :

http://freepdfhosting.com/853e428dfc.pdf

http://freepdfhosting.com/478ee737d0.pdf


-Jacob Clark
Jacob@BehemothDrivetrain.com
270 287 8663 call/text



 
Last edited:
B

BehemothDT

New Member
Please PM quotes. I have some other similar pieces I will be posting up later. Thanks for the responses I had no idea I would get this much interest. I will be reviewing quotes for the next two weeks then making a decision.

Sent from my SAMSUNG-SGH-I997 using Tapatalk 2
 
B

BehemothDT

New Member
Thanks for all the quotes. Unfortunately a couple of our prototypes developed a slow leak so we need to add a 0.055" deep x 0.080" wide oring groove on the 0.472" diameter. Also we are going to change the depth of the drill/tapped hole. They will be 0.200" more shallow than the print shows. I will get an updated PDF up asap.

Sent from my SAMSUNG-SGH-I997 using Tapatalk 2
 
B

BehemothDT

New Member
http://freepdfhosting.com/761372d517.pdf

Here is an updated PDF link of the small shaft. The changes will be the same to the large shaft. I'll get an updated print for it asap.

Please PM any quotes. Even if you email, send a PM also. We just want to make sure we are dealing with someone established on this site and not just trolling websites. Thanks.
-Jacob
 
Status
Not open for further replies.
Top