Hey everyone. I have a part that needs a 4ax Lathe.
It's a turned + milled 6061 part, OD approx. 1.3in. Tolerances are all ±.005. There's 3/8" centerbore through the entire part. Quantity 24+. Medium surface finish is acceptable, N10 or under.
The centricity of the bore isn't critical, but normality is. It could definitely be done with a well fixtured drill press.
I can supply all necessary models & drawings.
Thanks!
It's a turned + milled 6061 part, OD approx. 1.3in. Tolerances are all ±.005. There's 3/8" centerbore through the entire part. Quantity 24+. Medium surface finish is acceptable, N10 or under.
The centricity of the bore isn't critical, but normality is. It could definitely be done with a well fixtured drill press.
I can supply all necessary models & drawings.
Thanks!
Last edited: