Search results

We can likely do these for about $300 per mold. Please contact us.

We require 300 of these annually and request deliveries of 100 each at this time and will accelerate to 200 each in 2015. We will need good performance on the first batch of 100 though due to our stock totals. Please PM rather respond to forum post. There "may" be very minor adjustments to...

Final blank size is .625x1.50x5.50". Willing to consider options on getting there. Will consider hot rolled or cold drawn but prefer CDA. Need approx 100lbs of material per order. Desire to establish relationship with a vendor for this material.

Desire is to receive 2 deliveries of 100 each. Grind finish is not called in drawing and may be negotiable. Approx Ra 5-30. Material has been left open but previous material used was carborized 8620. We will award these within 1 week and looking to receive at least 50 of these as soon as...

Please quote the following part. We want to quote 150 each on this first batch and may later follow up with a blanket annual contract for future allocations as this is a production part. The material is open to the supplier as long as it meets our surface hardness requirements but subject to...

You are worrying me a bit. You may want to read the HT spec. It calls for HT before machining. It is very machinable..We do it every day.

The heat treat would require treatment and inspection per MIL-H-6875. I believe that is 100% inspection of each bar. I WILL tell you that most HT cos do NOT do that even though they charge for it. WE have caught that several times here. If you run spindle length bars, that would be 1 dimple...

I would like to note that all processes ( material, heat treat, passivate, and dry film lube) must be certified and be accompanied with certs with delivery. If your shop is certified to do this work, that will be very helpful for you.

The tip of the part is radiused so should not come to a point if I understand your questions right. The 15* angle and rad are 360* around the part so you will just turn the nose on to the part. The slot is 1.20" deep from the back of the part. We typically put that slot in with a 1/8" EM...

These parts are from 17-4PH with H-900 HT. Material dim is 5/16 round rod. The OD of the pins do not need turned. They are accepted as extruded. Please also see the passivate and dry film lube to be added. Please note that there is a slot to be added that is not on the print that is an open...

We have a sub spindle, Y axis, 2.6" bar cap lathe that has open time on it. If you have mill/turn parts to be run, let us know. We also have basic 2 axis turning and 4 axis milling and could certainly load those machines as well.

We estimated the gear tooth pitch by measuring just to make a model but will need to send samples to our selected vendor for proper matching. We really want to keep these in the states and lead time is very important on the first batch. These will be repeat orders with annual usage of...