davidy
New Member
Hello everyone,
I'd greatly appreciate a quote for the following part. It's a rectangular piece with rounded edges(0.320±0.005") and a 0.090" 45º chamfer all the way around on the top side, and two 1/4-28 0.200" deep threaded holes on the back side. The top face is milled to remove any surface imperfections(back will not be seen so surface finish isn't important). Back facing edges should be de-burred.
I'm looking for a quote for 100 and 250 pieces.
Dimensions come in at:
Height: 2.980±0.005"
Width: 2.330±0.005"
Thickness: 0.2400±0.005"
Rounded edges: 0.320±0.005" @ 0.090"
Two threaded holes: 1.125" north/south from center of part @ 0.200" deep 1/4-28 thread pitch.
Material: 6061-T6 Aluminum
Top face(milled surface with chamfer along edge)
Back face(two threaded holes 1/4-28 0.200" deep)
DXF File: View attachment 1.dxf
If you require any additional information, I'm more than happy to provide what I can, just reply below or shoot me a PM.
Thank you all for taking the time to consider this job!
I'd greatly appreciate a quote for the following part. It's a rectangular piece with rounded edges(0.320±0.005") and a 0.090" 45º chamfer all the way around on the top side, and two 1/4-28 0.200" deep threaded holes on the back side. The top face is milled to remove any surface imperfections(back will not be seen so surface finish isn't important). Back facing edges should be de-burred.
I'm looking for a quote for 100 and 250 pieces.
Dimensions come in at:
Height: 2.980±0.005"
Width: 2.330±0.005"
Thickness: 0.2400±0.005"
Rounded edges: 0.320±0.005" @ 0.090"
Two threaded holes: 1.125" north/south from center of part @ 0.200" deep 1/4-28 thread pitch.
Material: 6061-T6 Aluminum
Top face(milled surface with chamfer along edge)
Back face(two threaded holes 1/4-28 0.200" deep)
DXF File: View attachment 1.dxf
If you require any additional information, I'm more than happy to provide what I can, just reply below or shoot me a PM.
Thank you all for taking the time to consider this job!