Small Job Quote Needed 6061 Aluminum Oxygen Sensor Bungs

[Drag_S14]

Looking to get 10 or so of these made, maybe more depending on price.

Material: 6061 T6 (not supplied)
Overall length needs to be 5/8". 1/2" above the step, 1/8" below. Length can be slightly longer either way, but no shorter. Flatness needs to be respectable on the larger side, small side will be fine as-machined. Center needs to be tapped for 18x1.5mm thread. OD on the big side is 1", but can be very slightly smaller if it will save cost; down to .97" would be acceptable. OD on the small end is .900, with the same standards as the big end; down to .87" would be acceptable.

I would like to have parts in hand withing 2 weeks of a winning bid/payment.
Quote will close in 1 week, 4-26-2011.

I have drawings attached as exported by SolidWorks 2009. I can also provide the SolidWorks model upon request.

My email is Blake@geektuned.com

Thanks!
-Blake

Also, check out my other thread for CNC work, if you can do both that's even better!
http://www.rfqwork.com/showthread.php/2188-6061-Aluminium-Plate-Milling

 

[lincoln]

email sent,
Thank you, Link

 

[Drag_S14]

Sorry everyone, been away from the computer for a couple days. I'll be replying to everyone shortly. Thanks for all of the interest so far!

 

[FalconMachineParts]

PM sent. We are able to do both projects. Looking forward to your response. Thanks much. Ben

 

[productivity1]

Blake, we would like to quote this can you send me the drawing in a different format.

Thanks!

Craig.

 

[Drag_S14]

This job has been awarded, thanks to all that submitted quotes.