Looking to get 10 or so of these made, maybe more depending on price.
Material: 6061 T6 (not supplied)
Overall length needs to be 5/8". 1/2" above the step, 1/8" below. Length can be slightly longer either way, but no shorter. Flatness needs to be respectable on the larger side, small side will be fine as-machined. Center needs to be tapped for 18x1.5mm thread. OD on the big side is 1", but can be very slightly smaller if it will save cost; down to .97" would be acceptable. OD on the small end is .900, with the same standards as the big end; down to .87" would be acceptable.
I would like to have parts in hand withing 2 weeks of a winning bid/payment.
Quote will close in 1 week, 4-26-2011.
I have drawings attached as exported by SolidWorks 2009. I can also provide the SolidWorks model upon request.
My email is Blake@geektuned.com
Thanks!
-Blake
Also, check out my other thread for CNC work, if you can do both that's even better!
http://www.rfqwork.com/showthread.php/2188-6061-Aluminium-Plate-Milling
Material: 6061 T6 (not supplied)
Overall length needs to be 5/8". 1/2" above the step, 1/8" below. Length can be slightly longer either way, but no shorter. Flatness needs to be respectable on the larger side, small side will be fine as-machined. Center needs to be tapped for 18x1.5mm thread. OD on the big side is 1", but can be very slightly smaller if it will save cost; down to .97" would be acceptable. OD on the small end is .900, with the same standards as the big end; down to .87" would be acceptable.
I would like to have parts in hand withing 2 weeks of a winning bid/payment.
Quote will close in 1 week, 4-26-2011.
I have drawings attached as exported by SolidWorks 2009. I can also provide the SolidWorks model upon request.
My email is Blake@geektuned.com
Thanks!
-Blake
Also, check out my other thread for CNC work, if you can do both that's even better!
http://www.rfqwork.com/showthread.php/2188-6061-Aluminium-Plate-Milling