Cpt.Planet
New Member
1) 6061 Alu
2) Material Supplied by you
3) 2 for prototype up to 10 more in the near future
4) Check drawings for specs. Tolerances are +-.001in Any questions email me. This does need to be 1 solid piece
5) 4 weeks
6) 30 days
7) mrjake22@gmail.com
8) The 4 holes need to be tapped with 6-32. The drill should go down .48 in so it doesn't go into the large hole. The tap can do down .3in or further.
9) The finish on the 1.74 x 1.74 extrusion needs to be flat to .0001in and free of any gouges or nicks. The better the quality on this particular spot the better. However this is the most important spot the rest of the outside I would like to be smooth as well. Inside I'm not to worried at the least. The rougher the better.
If you think I left out any measurements I included a link to the solidworks .sldprt file as well thanks.
http://rapidshare.com/files/32456687/gpurev5.SLDPRT
2) Material Supplied by you
3) 2 for prototype up to 10 more in the near future
4) Check drawings for specs. Tolerances are +-.001in Any questions email me. This does need to be 1 solid piece
5) 4 weeks
6) 30 days
7) mrjake22@gmail.com
8) The 4 holes need to be tapped with 6-32. The drill should go down .48 in so it doesn't go into the large hole. The tap can do down .3in or further.
9) The finish on the 1.74 x 1.74 extrusion needs to be flat to .0001in and free of any gouges or nicks. The better the quality on this particular spot the better. However this is the most important spot the rest of the outside I would like to be smooth as well. Inside I'm not to worried at the least. The rougher the better.
If you think I left out any measurements I included a link to the solidworks .sldprt file as well thanks.
http://rapidshare.com/files/32456687/gpurev5.SLDPRT
Attachments
Last edited: