I want a die set that can be used with a garage scale 40t hydr. press to stamp out some small brass eschecucean plates, one at a time.
. Please see photo attached.
The ones I wish to copy are about .020thick brass.
I will need both halves of the die, and it should be hardened.
The part I need is only 1.375 dia, but has some depth to it....about 3/8 inch.
I may need a progressive die set as well, I do not have any experience with this.
I am just a hobbyist, and only plan on making about 120 of these parts for re-sale.
laheyt@bellsouth.net
. Please see photo attached.
The ones I wish to copy are about .020thick brass.
I will need both halves of the die, and it should be hardened.
The part I need is only 1.375 dia, but has some depth to it....about 3/8 inch.
I may need a progressive die set as well, I do not have any experience with this.
I am just a hobbyist, and only plan on making about 120 of these parts for re-sale.
laheyt@bellsouth.net
Attachments
Last edited: