kuhlmann75
New Member
Hello, I am looking for a shop that can manufacture small inserts on 0.230-0.234 thick aluminum (6061-T6). They are 2.058" long x 0.397" wide, on a 9.000" center line radius. These will be engraved, but I will do that here - I just need someone who can produce the blanks.
There is a hole on the back side that will be bottom-tapped with an M5, approximately 0.160" deep. I can accept quotes with the tapped hole, or just the machined hole - I can tap them myself if needed.
Please take a look at the attached file and message me with any questions.
I need pricing and lead time for quantities of 500, 1000, and 2000.
Thanks in advance...
Andy
There is a hole on the back side that will be bottom-tapped with an M5, approximately 0.160" deep. I can accept quotes with the tapped hole, or just the machined hole - I can tap them myself if needed.
Please take a look at the attached file and message me with any questions.
I need pricing and lead time for quantities of 500, 1000, and 2000.
Thanks in advance...
Andy